Start The Pump; Stop The Pump - Smiths Medical CADD Solis VIP 2120 Clinicians Manual

START THE PUMP

Infusion begins when the pump starts.
When the pump is running, "Running"
appears on the status bar, the graphic
on the home screen is green, and the
green indicator light flashes. If the
pump will not start, a message appears
on the display.
Note: Before starting the pump, be
sure the tubing is primed and the pump
is connected to the patient according to
your facility's standards of practice.
1. Press Stop/Start
Note: If the delivery settings have not
been reviewed and the values have not
been accepted, you must do so before
the pump will run. (See instructions
to review pump settings on page
12.) If a step or taper infusion was
previously stopped and delivery was not
completed (the infusion was not fully
delivered), a screen appears with the
message, "Infusion was interrupted
before completion. Finish interrupted
infusion or start from beginning with
new bag." Select New Bag to reset the
reservoir volume and reset the infusion.
Or, select Finish to resume the infusion
from the point it was at when it was
last running.
2. When "Start Pump?" appears,
select Yes
3. The pump begins running. The
red "Stopped" message in the
status bar changes to a green
"Running" message, and "Infusion
is starting now..." appears briefly
on the screen.
CADD -Solis VIP Pump
®
If a delayed start was programmed,
the display turns green and a
message that the infusion is
delayed appears briefly on the
screen. Then the "Delayed Start"
screen appears along with the
time remaining until the infusion
starts. The pump infuses at the
programmed KVO rate

STOP THE PUMP

Stopping the pump stops delivery.
After the pump is stopped, "Stopped"
appears in red on the status bar, the
graphic on the home screen is red, the
amber indicator light flashes, and the
green indicator light is off.
Press Stop/Start. In a PCA protocol,
1.
if a PCA dose is in progress, "Stop
PCA dose?"appears. Select Yes to
stop the dose. In a PCA protocol,
if a clinician bolus is in progress,
"Stop clinician bolus?" appears.
Select Yes to stop the bolus. A
confirmation screen appears
stating, "Clinician bolus stopped."
Select OK to continue. In a taper
protocol, "Taper down instead?"
appears. Select No to stop
the infusion
2. When "Stop Pump?" appears,
select Yes
3. The pump stops running. The green
"Running" message in the status
bar changes to a red "Stopped"
message, and "Pump is stopping..."
appears briefly on the screen
p. 31