Procedure For Setting Parameter - Oval EL0137 Instructions Manual

E-126-3-E

10.7 Procedure for setting parameter

The setting of parameter can be changed following the procedure shown below.
PROG
(1) Push switch long in "measurement mode" to enter "confirmation mode".
PROG
(2) Operate ,
PROG
(3) Push switch to enter "parameter setting mode".
(4) The program indicator will start flashing.
(5) Carry out the setting using
(6) After the input is finished, push
PROG
(7) Push switch long to return "measurement mode".
* If the operation is left for 20 seconds in the status (4) without any key operation, the status will return to (2).
Measurement mode
(normal mode)
2
CLEAR
SELECT
, and switches to display the parameter to be changed.
CLEAR
SELECT
and
PROG
switch to enter "confirmation mode".
(1)
(7)
Fig. 10.2 Flow of change of parameter setting
switches.
(2) (3)
Confirmation mode
(6)
Parameter
(4) (5)
setting mode