To Change Or Select A Value; To Return To The Measurement Mode - Oval EL0137 Instructions Manual

10.4 To change or select a value

When a parameter is changed, ▲ and ▶ indicate the transition direction of value or digit etc.
Even after the data is changed, the change is not reflected until
PROG
without pushing
NOTE: The change of parameter is reflected after

10.5 To return to the measurement mode

● Push Ⓐ
● The program indicator starts flashing.
● Select / input a value using Ⓑ
● To check the value / selection, push Ⓒ
● To change a value, select a digit using
SELECT
using
or keep pressing it for three seconds, the change will be cancelled.
If you press
two minutes, the mode will automatically return to the measurement mode.
PROG
.
SELECT
.
PROG
is pushed. If 20 seconds or more elapses
PROG
is pressed.
PROG
for three seconds or do not press any optical switch for
E-126-3-E
CLEAR
or Ⓒ
.
PROG
.
CLEAR
and increase the value
23