Table of Contents
Advertisement
10. PARAMETER SETTING
The parameter setting of EL0137 is implemented in the parameter setting mode. The mode shifts to the
parameter setting mode by pushing
for three seconds or leave it for three minutes without pushing any key, the parameter change mode can return
to the measurement mode. It is possible to shift to the parameter change mode even during measurement. In
this case, note that the change of setting may affect the measurement.
NOTE: If the protection by password is required, it is necessary to set it by COdE shown in the section 10.6.6
setting mode.
If the password is set, the parameter cannot be changed without inputting the password.
10.1 To enter the parameter setting mode
10.2 Structure of parameter
1.2
1.1
1
You can select a parameter by selecting the large classification and scrolling the small classification.
Example of operation for selecting 1.3: 1▲, 1.1▲, 1.2▲, 1.3
Example of operation for selecting 3.1: 1▶, 2▶, 3▲, 3.1
PROG
Pushing
scrolls the large classification backward (example 4
CLEAR
Pushing
scrolls the small classification backward (example 1.3
PROG
for seven seconds while the key is unlocked. If you push
PROG
Push
for seven seconds.
2.1
2
function-group
Each parameter item has an inherent
number that is displayed in the lower field of
the display. The number is configured with
two numbers. The figure left shows the
items of large classification and small
classification. Each item is represented by
keyword.
PROG
PROG
3
2
CLEAR
CLEAR
1.3
E-126-3-E
PROG
PROG
1).
1.1).
21
Advertisement
Table of Contents
