Section 5. Maintenance And Storage; Maintenance; Storage - Jandy JCP Series Installation And Operation Manual

Page 14
ENGLISH

Section 5. Maintenance and Storage

5.1

Maintenance

A misaligned basket will cause the lid to be
improperly seated, allowing an air leak, which could
result in pump damage.
The strainer built into the pump should be inspected and
cleaned daily. These strainers are easy to clean. Follow
the instructions printed on the locking ring.
1. Remove the lid's center plug and seal.
2. Turn the locking ring counter-clockwise until the lid
and locking ring come free from the strainer pot.
3. Inspect the lid O-ring for damage and replace if
necessary.
4. Remove the basket and clean.
5. Install the lid and locking ring by turning clockwise
until the arrows printed on the locking ring align
with the pump inlet and outlet ports. When properly
locked, the locking ring should click into place and
the handles should be perpendicular to the pump
ports.
6. Install the lid's center plug and seal.
7. The electric motor has sealed bearings and requires
no lubrication maintenance.
5.2

Storage

The pump must be protected when freezing
temperatures are expected. Allowing the pump to
freeze will cause severe damage and may void the
warranty.
Do not use antifreeze solutions in the pool,
spa, or hot tub systems! Antifreeze is highly toxic
and may damage the circulation system. The only
exception to this is Propylene Glycol. For more
information, see your local pool/spa supply store or
contact a qualified swimming pool service company.
If the pool is deactivated for an extended period of time,
care must be taken to protect the pump and motor from
damage and ex posure. If storage is necessary for an
extended period, place the motor and impeller assembly
in a warm, dry location.
NOTE:
Make sure power is turned off at the control
panel. Drain the pump by removing both drain plugs.
Disconnect the suction and discharge lines at the flange
connections, then move unit to warm, dry indoor location.
Jandy JCP Series High Performance Commercial Pumps
®
CAUTION
CAUTION
CAUTION
When activating the pump again, reverse the above
procedures. Replace the O-ring between the strainer pot
and pump housing if damaged. Install drain plugs. Check
the pump shaft for free movement. Prime the pump as
above and check the rotation of pump shaft.
|
Installation & Operation Manual