Procedure 6.7 - Replacing The Line Filter - Precor 9.31 Manual

Procedure 6.7 - Replacing the Line Filter

1. Set the treadmill circuit breaker in the "off" position and unplug the treadmill's line cord from
the A.C. outlet.
2. Remove the treadmill's motor cover.
3. Make note of where the two blue, two brown and green/yellow are connected to the line
filter. See Diagram 6.5. Disconnect all of the wiring from the line filter.
4. Remove the mounting hardware that fastens the line filter to the mounting panel and remove
the line filter.
5. Set the replacement line filter in it's mounting position, the side with three terminals must
face the circuit breaker. Fasten the line filter to the mounting panel with the mounting
hardware removed in step 3.
6. Connect the wiring to the line filter as noted in step 3.
7. Replace the treadmill's motor cover.
8. Check treadmill operation per Section 3.
9.31, 9.33, 9.35 Treadmill
Page 41