Precor 9.31 Manual page 4

5. KEYBOARD TEST.
6. The keyboard test will place a dot on the display for each key on the display, including the
numeric keypad. Pressing a key will cause the dot associated with the key to go out. Test all
of the keys in this manner. Tug on the safety key lanyard, to ensure that the STOP key is
activated.
7. Press and hold the OK or ENTER key to exit the keyboard test.
8. HEART RATE TEST.
9. The heart rate test will display the heart rate being received during this test from the hand
held grips, chest strap transmitter or test transmitter.
10. The display will toggle between unfiltered and filtered heart rate readings. They will be
prefixed "U" for unfiltered, "F" for filtered. When a heart rate signal is being accepted the
"heart" will blink and the heart rate will be displayed in the heart rate window and the main
window. Test the heart rate in both the hand held and wireless (chest strap or test
transmitter) modes.
11. Press the OK or ENTER key to exit the heart rate test.
12. MACHINE TEST.
13. There are two test modes in the MACHINE TEST, they are BELT SPEED and INCLINE.
Use the ARROW keys to select the desired test.
14. BELT SPEED
15. Press the OK or ENTER key. POWERBITS will be momentarily displayed then the powerbit
number will be displayed. The power bit level can be checked by starting the running belt.
16. Press the OK key to exit the belt speed test.
17. INCLINE
18. Press the OK or ENTER key. A/D will be momentarily displayed then the analog to digital lift
position number will be displayed. The analog to digital lift position number represents the
incline's physical position. The A/D number is used to calibrate the incline. The incline must
be calibrated when a new lift motor is installed.
19. Press the RESET to exit the MACHINE TEST.
9.31, 9.33, 9.35 Treadmill
Page 4