Precor 9.31 Manual page 6

12. Press the OK or ENTER key to exit the U Boot SW display
13. U BASE SW
14. Press the OK or ENTER key. The U Base SW part number will be displayed. The U Base
SW is the upper PCA operating system software.
15. Press the OK or ENTER key to exit the U Base SW display.
16. LOWER SW
17. Press the OK or ENTER key. The Lower SW part number will be displayed. The Lower SW
is the lower PCA operating system software.
18. Press the OK or ENTER key to exit the Lower SW display.
19. METRICS BOARD SW
20. Press the OK or ENTER key. The metrics board software part number will be displayed.
21. Press the OK or ENTER key to exit the metrics board SW display.
22. USAGE LOG
23. Press the OK or ENTER key. The usage for each program can be displayed. The ARROW
keys will allow to scroll through the list of programs. For example the manual program usage
will be displayed as MANUAL USED X TIMES TOTAL X MINUTES.
24. Press the OK or ENTER key to exit the usage log display.
25. ERROR LOG
26. Press the OK or ENTER key.
27. The error log will store up to 10 error conditions. The errors are logged with the most recent
error in position one. When a new error condition occurs, each existing error is pushed down
one position in log. If there was an error in position 10 when a new error was logged, the
error that was in position 10 will be lost.
28. Each error in the log will show the odometer reading (in miles) and the time (hour meter) and
motor current reading when the error occurred. The errors are displayed as;
1 ER20
29. The ARROW keys will allow you to scroll through the log.
30. When the QUICK START key is held for 2 seconds the message HOLD TO CLEAR
ERRORS will be displayed. If the QUICK START key is held for an additional 2 seconds, the
log will be cleared. The message NO ERRORS will be displayed and all error are erased
from the log.
XXXXX MI XXX HRS. XX.X AMPS
9.31, 9.33, 9.35 Treadmill
Page 6