Charging Procedure Dual Battery; Inserting And Removing The Battery - Raleigh Stride 2 User Manual

5.4.2 Charging procedure Dual Battery

If two batteries are installed on your Raleigh Stride cargo bike, both batteries can be
charged via the unsealed connection. First, both batteries are charged consecutively
to approx. 80–90%, then both batteries are charged in parallel (the LEDs of both
batteries flash). During use, both batteries are alternately discharged. If you take the
batteries out of the holders, you can charge each battery individually.
For complete information about the Bosch Powerpack and Charger, see the Bosch
User Manual supplied.

5.4.3 Inserting and removing the battery

In order for the battery to be inserted, the key must be inserted into the battery lock
and the lock must be open. To insert the standard battery, place it onto the contacts
on the lower holder on the Raleigh Stride (the battery can be titled towards the frame
by up to 7°). Tilt it into the upper holder as far as possible until you hear it click into
place. Check that the battery is secure in all directions. Always secure the battery by
closing the lock – otherwise the lock may open, and the battery may fall out of the
holder.
Always remove the key from the lock after closing it. This prevents both the key from
falling out and the battery from being removed by unauthorised third parties when
the e-bike is not in use. To remove the standard battery, switch it off and open the
lock using the key. Tilt the battery out of the upper holder and pull it out of the lower
holder.