Table of Contents
Advertisement
5.3.2 Setting the assistance level
On the on-board computer (9), you can set the level of assistance you want while
pedalling. The assistance level can be changed at any time, even while cycling. The
following assistance levels are available as a maximum:
● OFF: Motor assistance is switched off. The Raleigh Stride can just be moved by
pedalling, as with a normal bicycle. The walk assistance cannot be activated at this
assistance level.
● ECO: Light assistance with maximum efficiency, for maximum range.
● TOUR: Steady assistance, with a long range for touring.
● SPORT: Powerful assistance for cycling in urban areas.
● TURBO: Maximum assistance for maximum speed or when driving uphill. The extent
of the assistance will be automatically set depending on:
- Selected level of assistance.
- Pedalling force.
- Load and speed.
- Terrain.
The electrical drive will assist you when pedalling up to a speed of 25 km/h or 15.5
mph. If you reach a higher speed than 25 km/h or 15.5 mph, the electrical drive will
automatically switch off. If the speed falls below 25 km/h or 15.5 mph, the electrical
drive will once again automatically switch on. To increase the assistance level, press
the + button (6) on the operating unit repeatedly until the required assistance level
appears on indicator (i). To decrease the assistance level, press the – button (5). The
requested motor output is displayed in the indicator (i). The maximum motor output
depends on the selected assistance level. When the on-board computer is removed
from the holder (4), the assistance level that was last displayed is saved; the motor
output indicator (i) remains empty.
5.3.3 Switching bike lights on/off
The front and rear lights can be switched on and off at the same time via the on-
board computer by pressing the + button (6) for a few seconds. When the lighting is
switched on, the illumination indicator will appear (h) on the display and when the
lighting is switched off, the illumination indicator will disappear (h). The on-board
computer saves the light status and activates this saved status accordingly after a
restart. Switching the bike light on and off has no effect on the back lighting of the
display. The front of the box of your Raleigh Stride is equipped with LED-light. This is
an extra LED-light, which is switched on automatically when the front light is
activated.
Advertisement
Table of Contents
