Table of Contents
Advertisement
Maintenance
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
WARNING
While maintenance or adjustments are being
made, someone could start the engine.
Accidental starting of the engine could seriously
injure you or other bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance. Also
push the wire(s) aside so it does not accidentally
contact the spark plug(s).
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Before each use or daily
Periodic Maintenance
Check for Loose Hardware
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Visually inspect machine for any loose hardware
or any other possible problem. Tighten hardware
or correct the problem before operating.
Check Discharge Gate
Closure
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Visually inspect that the discharge gate closes flat
against the discharge opening. If not, reshape
the discharge gate so it closes properly and
completely.
Maintenance Procedure
• Check for loose hardware.
• Check discharge gate closure.
Adjustments
Note: Disengage PTO, shut off engine, wait for
all moving parts to stop, engage parking brake, and
remove key before servicing, cleaning, or making any
adjustments to the unit.
Handle Adjustment
The handle allows the gate to be held in any position.
Adjust the tension of the pivot bolt and nut as shown
in Figure 26 for more or less resistance.
18
Advertisement
Table of Contents
