Maintenance; Recommended Maintenance Schedule(S); Periodic Maintenance; Check Blower Housing/Impeller - Exmark ULTRAVAC BAGGER 126-6954 Operator's Manual

Maintenance

WARNING
While maintenance or adjustments are being
made, someone could start the engine.
Accidental starting of the engine could seriously
injure you or other bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance. Also
push the wire(s) aside so it does not accidentally
contact the spark plug(s).

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
Before each use or daily
Every 25 hours
Every 50 hours
Yearly or before storage

Periodic Maintenance

Check Blower
Housing/Impeller
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Inspect for wear or damage daily. Replace or
repair worn parts as needed.
Note: When mowing in areas with sandy soil,
use low lift blades on the cutting deck and higher
cutting heights to minimize wear on the blower
components.

Check Bags

Service Interval: Before each use or daily
Maintenance Procedure
• Check the blower housing/impeller.
• Check bags.
• Clean muffler and rear frame area.
• Clean rear screen in the hopper.

• Lubricate grease fittings.

• Check condition of belt.
• Clean blower.
WARNING
The engine can become very hot. Touching a hot
engine can cause severe burns.
Allow the engine to cool completely before
service or making repairs around the engine area.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Inspect the bags for wear, tears, or damage.
WARNING
Under normal use the bag will deteriorate and
wear. Objects could exit through worn bag
at high speeds. Thrown objects can cause
serious injury or kill you or bystanders.
Check bags frequently for tears and holes.
Replace worn bags only with Exmark
replacement bags.
Lubricate Grease Fittings
Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with NLGI grade #2
multi-purpose gun grease.
17
Maintenance