Table of Contents
Advertisement
Figure 15
Vantage 60
1. Velcro strap
For Vantage 36 units: Remove the nut
from the carriage bolt on front left side
of the cutting deck, install the loom clip,
and replace nut (see Figure 16). Orient the
loom clip to the top.
Figure 16
Vantage 36
1. RH caster tire
2. RH front bracket
3. Velcro strap
4. Cable
I.
Use velcro straps to secure the cable.
For Vantage 48 and 52, see Figure 17.
For Vantage 60, see Figure 17 to install
the strap by the handle. Route the cable
under the RH frame bar and secure in the
locations shown in Figure 15.
g019817
g034187
5. Carriage bolt and nut
6. Loom clip
7. Muffler guard
For Vantage 36, continue to route the
cable behind the muffler guard and secure
it with a velcro strap as shown in Figure 16.
Apply another velcro strap to the LH
frame bar as shown in Figure 18.
Important: Keep the cable away from
heat sources such as the muffler and
manifold.
Important: Belt shields must be in
place before operating the Operator
Controlled Discharge accessory.
Vantage 48 and 52
1. Velcro strap
13
Setup
Figure 17
2. Loom clip
g012627
Advertisement
Table of Contents
