Programming And Users Management - ITS Telecom EKSELANS CCA 370001 User Manual

Table of Contents

Advertisement

Configuration in "Input Pass" (the same voltage that feeds the controller, will feed the lock). The lock
must be of the same power as the CCA.

6. Programming and Users Management

The programming of the cards is stored in the memory of the device so the system is robust in the event
of power supply drops. In the absence of power supply the controller will not be able to activate the
door opening, as it will not read the cards.
The system supports up to 1000 user cards. Each of them is registered in the system as they are
registered, with an identifier (0, 1, 2, ... 999).
Card management can be done by keyboard (remote control) or by other types of cards (called a
master).
Two cards are supplied to be configured as master. One will be used to discharge and the other to
unsubscribe the user cards. There can only be one set of master cards: Master-High and Master-Low.
If you delete out a second set of master cards, the previous one is voided.
ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · info@ek.plus · www.ek.plus
Important note:
It is not possible to know which identifier corresponds to each user card, so it
is recommended that a record is kept. Keeping the registry will allow deleting
a user card (without physically having it). If this is not the case, it will be
necessary to delete and re-register all the cards.
USER MANUAL CCA
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EKSELANS CCA 370001 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents