Programming Mode (Via Remote Control); User Management (Via Remote Control) - ITS Telecom EKSELANS CCA 370001 User Manual

6.2.2. Programming mode (via remote control)

In this mode it is possible to carry out the programming using the remote control by entering different
commands.
•
To enter this mode, press:
Enter in the programming mode
Exit the programming mode
•
To change the master code
Step 1
Step 2
Step 3
If you change the master code, remember it. Otherwise it will be necessary to make a factory default
reset.
It must have 6 digits.

6.2.3. User management (via remote control)

Each user card is registered with an identifier that matches its position within the system. The controller
can assign auto-incremented identifiers. You can also assign a specific identifier.
•
Subscribing:
To add user cards at a position given by the system:
Step 1
Step 2
Step 3
Remember that in the case there are empty positions not assigned to a card (Bubbles), this
process will assign to the card registered the first available position/identifier. A bubble will
appear when a specific card (Not the last one) has been removed.
ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · info@ek.plus · www.ek.plus
Enter in the programming
mode
Insert the new master code.
It's a 6-digit code
Exit the programming mode
Enter in the programming mode
Pass the card through the reader and
press Repeat this step if several cards
need to be registered
Exit the programming mode
USER MANUAL CCA
< Master code > (Default master code
123456)
< Master code >
0 < New master code >
< New master code >
< Master code >
1 < Sweep card >
11