Cloning Of Controllers - ITS Telecom EKSELANS CCA 370001 User Manual

Table of Contents

Advertisement

6.2.6. Cloning of controllers

ATTENTION CLONING CAN ONLY BE DONE WITH 12 VDC NOT IN AC. CLONE SO THAT THE CCA IN
WHICH THE CONFIGURATION IS TO BE DUMPED (THE RECEIVER) IS NOT VISIBLE FROM THE
CONTROLLER, SAVE IT IN A DRAWER OR COVER IT IF NECESSARY.
The controller may be cloned to another CCA controller. The copied data are the configurations of the
transmitter controller and the registered user cards.
Make the following connections:
Apply the following steps to the unit to clone (transmitter):
Step 1
Paso 2
Paso 3
Step 4
Note that:
Both units must have the same master code.
A cloning process with 1000 registered users may last up to 3 minutes.
Check connections. Avoid short circuits.
ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · info@ek.plus · www.ek.plus
Enter in the programming mode
Start the transfer
Wait until the transmission ends
Exit the programming mode
USER MANUAL CCA
< Master code >
9 6
The green LED blinks
14

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EKSELANS CCA 370001 and is the answer not in the manual?

Table of Contents