Page 1
Purpose: The Sleeq Flex spinal orthosis is an orthosis for active relief and correction of the lumbar and the thoracic spine in the sagittal plane. The orthosis may only be used for lower spine treatment. This device is intended only for the treatment of the indications listed and for patients whose measurements correspond to the sizing table.
Page 2
1.0 BRACE COMPONENTS BRACE COMPONENTS SIZING ARCS EXT-EXTENSION PANEL WING *(Sold Separately) THORACARE SUPPORT PULL TAB SHOULDER STRAPS SIZING GUIDE LATERAL PANEL (2) VELCRO® CONNECTOR 2.0 SIZING PULL VELCRO WING CONNECTOR Size Determination and Adjustment Customize for waist to hip disparities: Follow Refer to Sizing Guide (C) to determine wing procedures from section 2.1-2 to release wing.
Page 3
2.0 Donning/Doffing First loosen the shoulder straps, Adjust “ThoraCare” strap up or down to don brace over the shoulders. accommodate larger patients. Position brace to desired height (T-3 / scapular spine level). (1) Wrap left wing to align with Detach pull tabs and adjust Pull downward on straps to medial line of abdomen.
Page 4
Dispose of in accordance with local regulations. Limited Warranty: Thuasne USA will repair or replace all or part of the unit and its accessories for material or workmanship defects for a period of six months from the date of sale. KEEP THESE INSTRUCTION www.thuasne.com...
Need help?
Do you have a question about the SLEEQ FLEX and is the answer not in the manual?
Questions and answers