Safety; Product Maintenance; Symbols Explanation - EMP-Centauri MS5/12ELP-4 Instruction Manual

• Connect input F sockets marked A–D and TERR IN with LNB, terrestrial antenna, amplifier...
•
Connect user outputs 1–12 (or 1–16, according to type) to suitable wall sockets.
• Connect socket „DC 5–12 V in" to external power supply, if active terrestrial antenna is used
Note: Use only Quattro LNB.
Set the satellite receiver for reception from single satellite position using universal Ku Band LNB; no
additional (DiSEqC) setting is required.
The wiring examples are shown in the section 9) Wiring Diagrams or at www.emp-centauri.eu.

6) Safety

Due to security reasons the product and wiring in which the product is connected, must be grounded
properly. Make sure the antennas are grounded properly. Connect all devices to power grid only after all
connections are finished and checked. Never work on the wiring (including satellite and terrestrial receivers,
TVs) during or before a storm. A lightning stroke into the antenna may cause dangerous overvoltage in the
product metallic parts. The product should be disconnected from the wiring immediately if it gets into
contact with liquids (dropping water, spilled drinks etc.).

7) Product Maintenance

To clean the product, use a dry cloth without liquid detergents.

8) Symbols Explanation

certificate of conformity
According to EU directive, electric and electronic devices which are identified by one of the
following symbols must not be disposed of together with municipal waste. When disposing of
the old device, use local waste collection and separation systems.
3 of 4