Table of Contents
Advertisement
A M P 1 I N T E G R AT E D P O W E R A N D E N E R G Y I N S TA L L AT I O N I N S T R U C T I O N S
AMP1N4
Enclosure for AMP1 series energy meters with swing panel kit
FCC PART 15 INFORMATION NOTE: This equipment has been
tested by the manufacturer and found to comply with the
limits for a class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a residential environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. This device complies with part 15 of the FCC
Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device
must accept any interference received, including interference
that may cause undesired operation.
Modifications to this product without the express
authorization of the manufacturer nullify this statement.
A qualified person is one who has skills and knowledge related
to the construction and operation of this electrical equipment
and the installation, and has received safety training to
recognize and avoid the hazards involved.
NEC2011 Article 100: No responsibility is assumed by
manufacturer for any consequences arising out of the use of
this material.
Control system design must consider the potential failure
modes of control paths and, for certain critical control
functions, provide a means to achieve a safe state during and
after a path failure. Examples of critical control functions are
emergency stop and over-travel stop.
For troubleshooting or service related questions, contact ABB at 800-782-8061 or at epis.component.support@abb.com
This symbol indicates an electrical shock hazard
exists.
Documentation must be consulted where this
symbol is used on the product.
DANGER: Hazard of Electric Shock, Explosion or Arc Flash
Failure to follow these instructions will result in death or
serious injury.
• Follow safe electrical work practices. See NFPA 70E in
the USA, or applicable local codes.
• This equipment must only be installed and serviced by
qualified electrical personnel.
• Read, understand and follow the instructions before
installing this product.
• Turn off all power supplying equipment before working
on or inside the equipment.
• Use a properly rated voltage sensing device to confirm
power is off.
• DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE
INDICATION
• Only install this product on insulated conductors.
NOTICE:
• This product is not intended for life or safety
applications.
• Do not install this product in hazardous or classified
locations.
• The installer is responsible for conformance to all
applicable codes
• Mount this product inside a suitable fire and electrical
enclosure.
29
Advertisement
Table of Contents
