1. Turn power off to the unit and unplug the unit from The purpose of this procedure is to establish the the wall outlet. necessary guidelines to convert a Triton Model 9650 to the Triton Model 9600. 2. Open the door to the security vault. Disconnect all cables from the dispenser.
Page 3
9650- -9600 ONVERSION ROCEDURE 5. Disconnect the DB 15 cable from the E.J. using a small flat head screwdriver. DB15 Cable Connector 8. Remove the Power Supply Assembly from the unit. 6. Disconnect all cables connected to the AC input 9.
Page 4
9650- -9600 ONVERSION ROCEDURE Use Rear Set of Mounting Holes 11. Close the power supply and install the two mounting screws back into the power supply plate. 12. Connect the DB 15 connector on the end of the 9600 E.J. to Mech-00 Disp. Cable (09600-00027) to the E.J.
Page 5
20. Refer to the 9600 Operations Manual for additional the dispenser. Make sure the DC power cable is information regarding the software setup of the unit. plugged into the mating connector properly For additional help, contact the Triton Technical before proceeding. Service Department. Raised Tabs 16.
Need help?
Do you have a question about the 9650 and is the answer not in the manual?
Questions and answers