Roverpet WP3624DSF Assembly Instructions

36” high 2'x4' whelping pen

Roverpet

20 Kiji Dava Circle Prescott, Arizona 86301

Roverpet #WP3624DSF – 36" high 2'x4' Whelping Pen Assembly Instructions

Whelping Pen shown attached to Whelping Box

Inventory list for Roverpet #WP3624DSF Whelping Pen:

(3) #136 – 36" high Panels

(18) #250 Floor/Divider Clips

(12) #200 Panel Clips (pre-attached to panel assembly by Roverpet)

Whelping Box sold separate!

Assembly Procedure

1.) Unpack contents of shipping carton and compare to inventory list above; the door and panels will arrive to

you in a pre-connected configuration from Roverpet.

2.) Unfold the panel assembly and arrange to resemble the picture above with the door positioned on the right

side of the Roverpet whelping pen.

3.) If you are attaching this Roverpet Whelping Pen to an already assembled Roverpet Whelping Box, remove

the #90 stabilizers from the corners closest to the door. If you are going to be attaching this Whelping Pen

to a Roverpet Whelping Box that has yet to be set up, assemble the Roverpet Whelping Box per the

instructions but leave the #90 stabilizers off of the corners closest to the door as they will be attached to the

corners of this Roverpet Whelping Pen instead.

4.) Attach the Roverpet Whelping Pen panel assembly to the Roverpet Whelping Box with the supplied #250

clips. Install the clips in four groupings of three that wrap completely around the three adjoining frame pipes

in a triangulated configuration as shown in the photo below. Each clip will connect to two panels only, so

this triangulated configuration is necessary to secure all thee PVC panels together.

1-800-658-5925

(1) #D36 – 36" high Door (3) #180 Straight Stabilizers

(1) #F24 – 2' x 4' Floor

rover@roverpet.com

Page 1 of 3

Table of Contents

Do you have a question about the WP3624DSF and is the answer not in the manual?

Page 1 #90 stabilizers from the corners closest to the door. If you are going to be attaching this Whelping Pen to a Roverpet Whelping Box that has yet to be set up, assemble the Roverpet Whelping Box per the instructions but leave the #90 stabilizers off of the corners closest to the door as they will be attached to the corners of this Roverpet Whelping Pen instead.
Page 2 Pen will rest around the outside of the #F24 floor frame 8.) Install (1) #250 floor clip in the middle of the Roverpet Whelping Pen. Snap the clip over the panel frame and #F24 floor frame, securing the panel to the #F24 floor.
Page 3 20 Kiji Dava Circle Prescott, Arizona 86301 1-800-658-5925 rover@roverpet.com Note: If your Roverpet Whelping Pen contains a door panel, place the (1) #250 clip just to the inside of the door opening area. Enjoy your new #WP3624DSF Roverpet Whelping Pen!