Roverpet WP3046DSF Assembly Instructions

Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
Roverpet #WP3046DSF – 30" high 4' x 6' Whelping Pen Assembly Instructions
Whelping Pen shown attached to Whelping Box
Inventory list for Roverpet #WP3046DSF Whelping Pen:
(7) #130 30" high panels
(32) #250 floor/divider clips
(24) #200 panel clips (pre-attached to panel assembly by Roverpet).
Whelping Box sold separate!

Assembly Procedure

1.) Unpack contents of shipping carton and compare to parts list above; the door and panels will arrive to you
in a pre-connected configuration from Roverpet.
2.) Unfold the panel assembly and arrange to resemble the picture above with the door positioned on the right
side of the whelping pen.
3.) If you are attaching this Roverpet Whelping Pen to an already assembled Roverpet Whelping Box, remove
the #90 stabilizers from the corners closest to the door. If you are going to be attaching this Whelping Pen
to a Roverpet Whelping Box that has yet to be set up, assemble the Roverpet Whelping Box per the
instructions but leave the #90 stabilizers off of the corners closest to the door as they will be attached to the
corners of this Whelping Pen instead.
4.) Attach the Roverpet Whelping Pen panel assembly to the Roverpet Whelping Box with the supplied #250
clips. Install the clips in four groupings of three that wrap completely around the three adjoining frame pipes
in a triangulated configuration as shown in the photo below. Each clip will connect to two panels only, so
this triangulated configuration is necessary to secure all thee PVC panels together.
1-800-658-5925
(1) #D30 30" high door
(3) #F24 2' x 4' floors
rover@roverpet.com
(7) #180 straight stabilizers
Page 1 of 2