Roverpet WP3044DSF Assembly Instructions

Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
Roverpet #WP3044DSF – 30" high 4' x 4' Whelping Pen Assembly Instructions
Inventory list for Roverpet #WP3044DSF Whelping Pen:
(5) #130 30" high panels
(24) #250 floor/divider clips
(18) #200 panel clips (pre-attached to panel assembly by Roverpet).
Whelping Box sold separate!

Assembly Procedure

1.) Unpack contents of shipping carton and compare to parts list above; the door and panels will arrive to you in a pre-
connected configuration from Roverpet.
2.) Unfold the panel assembly and arrange to resemble the picture above with the door positioned on the right side of the
whelping pen.
3.) If you are attaching this Roverpet Whelping Pen to an already assembled Roverpet Whelping Box, remove the #90
stabilizers from the corners closest to the door. If you are going to be attaching this Whelping Pen to a Roverpet
Whelping Box that has yet to be set up, assemble the Roverpet Whelping Box per the instructions but leave the #90
stabilizers off of the corners closest to the door as they will be attached to the corners of this Roverpet Whelping Pen
instead.
4.) Attach the Roverpet Whelping Pen panel assembly to the Roverpet Whelping Box with the supplied #250 clips. Install
the clips in four groupings of three that wrap completely around the three adjoining frame pipes in a triangulated
configuration as shown in the photo below. Each clip will connect to two panels only, so this triangulated configuration is
necessary to secure all thee PVC panels together.
Whelping Pen shown attached to Whelping Box
(1) #D30 30" high door
(2) #F24 2' x 4' floors
1-800-658-5925
(5) #180 straight stabilizers
Page 1 of 2
rover@roverpet.com