Roverpet WB3644DSF Assembly Instructions

Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
Roverpet #WB3644DSF – 36"high 4x4 Whelping Box Assembly Instructions
Inventory list for The Roverpet #WB3644DSF Whelping Box:
(7) #136 36" high panels
(1) #44PR5 5" high puppy rail assembly (two leg bars, two cross-bars and four legs
(1) #44DPK Designer Puppy Keeper (6" high)
(12) #250 floor/divider clips
(24) #200 panel clips (pre-assembled onto frames by Roverpet)

Assembly Procedure

1.) Unpack contents of shipping carton and compare to parts list above.
2.) Layout the two #136 panels / #D36 door sub-assemblies as show below, with the assembly containing the
door positioned on the right side.
#200 panel clips- pre-attached
to end panels here by Rover
Co.
3.) Connect the ends of the sub-assemblies together with the #200 panel clips that are already attached to the
end panels; reposition panels into a square shape resembling the main photo at the top of this page.
4.) Install #180 straight stabilizers onto the top of in-line connected panels (left photo below) and install #90
corner stabilizers onto the top of corner connected panels (right photo below).
5.) Lay floor trays side-by-side into the bottom of the Roverpet whelping box with the frame pipes facing up to
allow connection to the side panels.
1-800-658-5925
(1) #D36 36" high door
(4) #180 straight stabilizers
rover@roverpet.com
(2) #F24 2'x4' floors
(4) #90 corner stabilizers
Page 1 of 3