Roverpet WP3644DSF Assembly Instructions

Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
Roverpet #WP3644DSF – 36" high 4'x4' Whelping Pen Assembly Instructions
Inventory list for Roverpet #WP3644DSF Whelping Pen:
(5) #136 36" high panels
(24) #250 floor/divider clips
(18) #200 panel clips (pre-attached to panel assembly by Roverpet)
Whelping Box sold separate!

Assembly Procedure

1.) Unpack contents of shipping carton and compare to parts list above; the door and panels will arrive to you in a pre-
connected configuration from Roverpet.
2.) Unfold the panel assembly and arrange to resemble the picture above with the door positioned on the right side of
the whelping pen.
3.) If you are attaching this Roverpet Whelping Pen to an already assembled Roverpet Whelping Box, remove the #90
stabilizers from the corners closest to the door. If you are going to be attaching this Whelping Pen to a Roverpet
Whelping Box that has yet to be set up, assemble the Roverpet Whelping Box per the instructions but leave the #90
stabilizers off of the corners closest to the door as they will be attached to the corners of this Roverpet Whelping Pen
instead.
4.) Attach the Whelping Pen panel assembly to the Roverpet Whelping Box with the supplied #250 clips. Install the clips
in four groupings of three that wrap completely around the three adjoining frame pipes in a triangulated configuration
as shown in the photo below. Each clip will connect to two panels only, so this triangulated configuration is necessary
to secure all thee PVC panels together.
Whelping Pen shown attached to Whelping Box
(1) #D36 36" high door
(2) #F24 2' x 4' floors
1-800-658-5925 rover@roverpet.com
(5) #180 straight stabilizer
Page 1 of 2