Flashforge Creator 3 Pro Quick Start Manual page 5

Precautions for Unpacking the Equipment
1. Take out the top accessories and pearl cotton.
2. Remove the tape from the machine.
3. Take out the internal pearl cotton block.
4. Remove the buckles on the X-axis and Y-axis synchronous belts.
5. Connect the printer to the power supply, after power on, and then click [Tools] and
[Manual] in turn on the touch screen to enter the manual control interface.
6. Press and hold [Z-] continuously until the build plate rises to a higher position, and
then take out the foam block below.
03