Table of Contents
Advertisement
Getting Started
This section provides an introduction to the web-based configuration utility, and covers the following topics:
•
Powering on the device
•
Connecting to the network
•
Starting the web-based configuration utility
Power
Installing Power
Power down and disconnect the power cord before wiring a switch.
Do not disconnect modules or cabling unless the power is first switched off. The device only supports the
voltage outlined in the type plate. Do not use any other power components except those specifically
designated for the switch.
Disconnect the power cord before installation or cable wiring.
The Gigabit Ethernet Smart-Lite switch is powered by an external power adapter (5V DC/1A). Connect the power adapter
to an external power source and check the power LED is on.
10
Advertisement
Table of Contents
