Advertisement
Quick Links
Wall
C
Kickstand
Please check that the TV Wall Mount is secure and safe to use at regular intervals. If you have any
questions regarding any of the instructions or warnings, please contact your local distributor (OR)
contact QualGear technical support via email at support@qualgear.com.
CAUTION!
Do not exceed the maximum rated weight
50kg
50kg
specified. Otherwise, serious injury or
(110lbs)
(110lbs)
RATED
RATED
property damage may occur.
Version January 2016
Version January 2016
Advertisement
Related Manuals for QualGear QG-TM-001
Summary of Contents for QualGear QG-TM-001
- Page 1 Please check that the TV Wall Mount is secure and safe to use at regular intervals. If you have any questions regarding any of the instructions or warnings, please contact your local distributor (OR) contact QualGear technical support via email at support@qualgear.com. Version January 2016...
-
Page 2: Parts Checklist
Before starting installation, please check that all parts shown in this checklist IMPORTANT: are included. If any parts are missing or damaged, contact your local distributor or support@qualgear.com for replacement parts and do not start assembly and installation WARNING until you receive all the parts. - Page 3 Mounting to a Wooden Stud Wall For concrete or brick NOTE wall mounting, follow Step 1b. Stud Finder IMPORTANT: Minimum VESA for wooden stud installation is 400x400mm. If your TV has mounting holes closer than 400x400mm, do NOT use this mount. Wall Plate Mount the wall plates (A) and tighten them with the provided lag bolts (W-A) and D 6 washers (W-C) using a socket wrench.
- Page 4 Mounting to a Concrete or a Solid Brick Wall Place plastic anchors (W-B) in each hole. Tap each anchor flush with the wall using a hammer. Using a socket wrench, mount the wall plates and fasten them with the provided lag bolts (W-A) and D6 washers (W-C).
- Page 5 Installing the Adapter Brackets Installing to a Flat Back Panel of a TV Cable Tie Choose the appropriate screws, washers, and spacers (if necessary) according to the type of your T V and tighten the adapter brackets (B) and the kickstands (C) to (Length of wire rope, see Table 1a/1b) the back of the TV using a Phillips screw driver.
- Page 6 Installing to a Curved or Recessed Back Panel of a TV Hanging the TV onto the Wall Plates HEAVY! Use an assistant for this step. Wall Plate IMPORTANT! Tighten all screws but do NOT over tighten. Wire Rope M-D/ M-E/ M-F M-E/ M-F M-E/ M-F After the wall plates have been safely...