Setting Up Video Colposcope - Welch Allyn 88000A Directions For Use Manual

18 Connections and Assembly
12. Tighten the bolt securely with the enclosed Allen wrench. Be sure not to pinch any of
the electrical wires between the vertical pole and arm of the colposcope assembly.
13. Before using the Video Colposcope, refer to Setting Up Video Colposcope section of
this manual.

Setting Up Video Colposcope

1. Connect the power cord to the power cord receptacle in the power supply located on
the Video Colposcope stand.
2. Plug the other end of the power cord into a properly grounded 110-120 volt AC outlet
(220-240 volt, 50 cycle for international).
3. Connect the S-Video cable to the S-Video output on the side of the power supply
located on the Video Colposcope stand.
4. Connect the other end of the S-Video cable into the Line A connector S-Video (Y/C) on
the back of the monitor.
5. Plug the monitor into a properly grounded 110-120 volt AC outlet (220-240 volt, 50
cycle for international).
RS232 output
S-Video output
Power Cord
Welch Allyn Video Colposcope