Side-Discharging The Clippings; Operating Tips - Toro Reccycler Manual

Table of Contents

Advertisement

Available languages

Available languages

move the lever rearward until the button on the
lever pops up.
Important:
For proper operation, shut off
the engine, wait for all moving parts to stop,
and then remove any grass clippings and
debris from the bag-on-demand door and the
surrounding opening
move the bag-on-demand lever from 1 position
to another.
1. Clean here
Side-Discharging the
Clippings
Use side-discharging for cutting very tall grass.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position, move
the lever to the recycling position; refer to
the Bag-on-Demand Lever (page
Installing the Side-Discharge
Chute
Unlatch and lift up the side deflector and install the
side-discharge chute
(Figure
(Figure
18) before you
Figure 18
Operating
14).
19).
Removing the Side-Discharge
g027454
Chute
To remove the side-discharge chute, lift up the side
deflector, remove the side-discharge chute, and lower
the side-discharge deflector until it latches securely.

Operating Tips

General Mowing Tips
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, disconnect the
wire from the spark plug, remove the electric-start
button (if equipped), and examine the machine for
damage.
For best performance, install a new blade before
the cutting season begins.
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
Cut only about a third of the grass blade at a time.
Do not cut below 51 mm (2 inches) unless the
grass is sparse or it is late fall when grass growth
begins to slow down.
When cutting grass over 15 cm (6 inches) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
machine may plug and cause the engine to stall.
15
Figure 19
g235646

Advertisement

Table of Contents
loading

This manual is also suitable for:

2176221763

Table of Contents