Recycling The Clippings; Bagging The Clippings; Operating The Bag-On-Demand Lever - Toro Reccycler Manual

using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove it; refer to
15). If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to
the Bag-on-Demand Lever (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Install the grass bag, ensuring that the pins on the bag rest in the notches on the handle (B of
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
Operating the
Bag-on-Demand Lever
The bag-on-demand feature allows you to either
collect or recycle grass and leaf clippings while the
grass bag is attached to the machine.
•
To bag the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 17).
14).
Figure 16).
Figure 16
Installing the Grass Bag (page
14
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
15).
Removing the Side-Discharge Chute (page
14).
1. Bag-on-demand lever (in the bagging position)
•
To recycle or side-discharge the grass and
leaf clippings, press the button on the lever and
Operating
Figure
Figure 17
14). If
16).
g233434
g033491