Installation Guide
4.2 Ultrastar Serv60+8 Unpacking Procedure
Step 1 : Make sure that all of the necessary parts and equipment are available, including any equipment
necessary to support the enclosure during installation. To verify the list of necessary parts, see
Ultrastar Serv60+8 Packaging Overview (page
Step 2 : Using a box cutter, cut the straps that secure the packaging to the pallet.
Step 3 : Remove and discard the top cap and the outer sleeve.
Figure 11: Top Cap and Sleeve Removal
Step 4 : From the accessory tray, open the boxes for the rails, CMA arm, and top cover alignment
brackets. Remove these parts and set them aside.
4.2 Ultrastar Serv60+8 Unpacking Procedure
38).
4. Packaging
41