Table of Contents
Advertisement
Installation Guide
Part(s): N/A
Person(s): 1
Time: 5 minutes
Step 1 : Plug the enclosure power cords into a PDU.
Step 2 : Press the power button at the back of the enclosure to power it up.
Step 3 : Double check the power indicators and other LEDs to ensure that the system is booting.
See the following table for details on LED status during power-up:
Table 44: LED Status During Power-Up
W hat to do next: T he enclosure is now installed and ready for operation. For instructions on how to
operate the enclosure, please refer to the Ultrastar Serv60+8 User Guide.
Caution: The Ultrastar Serv60+8 can only be plugged into high line (200 - 240
VAC) power. If the unit is plugged into low line (110-127 VAC), the PSU will report a
"Critical" state when status pages are queried using SES. In this case, the enclosure
will power up, but the drives will not.
LED
Identify
Fault
Power
Note: If the connected SAS cables do not display activity (green LED), the
enclosure Fault LED may remain on after the primary expander is booted.
At Power-Up
On
On
On
5. Installation
5.9 Enclosure Power On
After Primary Expander
Booted (1-3 min.)
Off
Off
On
75
Advertisement
Table of Contents
