Advertisement
Adjust the Lens
Install Illuminators: FANG QIAN Three-In-One Intelligent Traffic Illuminators
The smart LED illuminator is used with super low-light checkpoint cameras. The following figures and table show the appearance, cable
connections, and schematic diagram of such smart LED illuminators.
Cable Type
Color
Description
Brown
220 V (live)
Power cable
(three-core
Blue
220 V (neutral)
cable)
Yellow-green
GND (earth)
Connects to the positive Boolean value terminal (for
Red
example, F1+) of the camera.
Connects to the negative Boolean value terminal (for
Black
example, F1-) of the camera.
Connects to terminal A (for example, D1+) of the camera's
Purple
RS-485 port.
Connects to terminal B (for example, D1-) of the camera's
Blue
RS-485 port.
Signal control
cable
Connects to the positive level output terminal (for example,
Brown
TTL T1) of the camera.
Connects to the negative level output terminal (TTL GND)
Gray
of the camera.
Connects to the positive level output terminal (for example,
Green
TTL T2) of the camera.
Connects to the negative level output terminal (TTL GND)
White
of the camera.
Determine Scenario
Requirements
Adjust the Illuminator
Install Illuminators
Note:
• A FANG QIAN three-in-one intelligent traffic illuminator needs to connect to two groups of
TTL signal cables, so it can be applied only to two-lane detection scenarios. RS-485 signal
cables are connected to optimize the illuminator brightness.
• Actual cables may vary. Please refer to the device label.
• Waterproof and insulate the pigtail cables to prevent water from entering the device. For
details, see the Quick Start Guide delivered with the camera.
10
Install and Adjust
Light Spot
Radar Detectors
Advertisement
