Optional Vineyard Wire Anti-Cutting Function; Storing The Shear; Troubleshooting; Routine Maintenance - CAMPAGNOLA Speedy Use And Maintenance Manual

5.2.1

Optional Vineyard Wire Anti-Cutting Function

The shear is fitted with an optional function, designed to avoid accidental cutting of the vineyard metallic wire.
Once the function is inserted, the operator grasps the vineyard wire with his free hand at a MINIMUM distance of at least
15 cm from the branch cutting point, that is to say, at least 15 cm from the shear blades.
The contact between the free hand and the wire can be either direct or preferably using conductive metal gloves.
In these conditions, if the blade accidentally touches the wire, the cut stops automatically and the blade returns to the open
position, thus avoiding any accidental damage to the wire and any consequent restoration costs.
Any other use of this optional function does not comply with the project. Therefore, it is not allowed and must be avoided in
the strongest terms, as it does not fall within the intended use and has been neither authorized by the shear designer nor
by its Manufacturer.
The Manufacturer declines any responsibility due to damage to things or people caused by an improper use of the tool,
which has not been authorized by the Manufacturer and does not comply with these instructions for this optional function.
Activation and deactivation of the optional vineyard wire-anti-cut function.
The shears are delivered with deactivated optional wire-anti-cut function.
Operate as follows to activate or deactivate this optional function.
• Switch off the shears
• Press and hold the power button pressed for at least 10 sec., until you hear the second "beep" (acoustic signal) in
sequence.
The optional function is now activated / deactivated.
For safety reasons, it is recommended to always deactivate this function when it is not necessary and, in any case, always
before storing the tool.
5.3

Storing the shear

• Keep the trigger pressed for few seconds until you hear 3 long beeps. The blades close and remain closed. Release the
trigger.
• Switch the shear off and remove the battery.
• Recharge the battery before putting it into its box.
• Clean the shear and put it back with its components into its box.
• Store the shear in a dry place.
• For long periods of inactivity recharge the batteries not later than every 3 months.
5.4

Troubleshooting

WARNING!
All the following maintenance operations shall be carried out by a maintenance technician.
FAULT
The shear cannot complete the cut. The branch diameter is over 25 mm or
The battery does not get completely
recharged.
Electric/mechanical wrong function-
ing
The tool does not work.
WARNING!
Failure to apply the instructions described in this manual could cause damages or injuries.
6.1

Routine maintenance

WARNING!
• Before carrying out any routine maintenance operation, put the ON/OFF button (5) in "OFF" position and remove
the battery (12) from the tool.
• All the maintenance operations which are not mentioned in this manual must be carried out at an Authorized
Service Point.
Routine maintenance operations can be carried out by the operators.
Use and maintenance manual – Translation of
original Instruction. : 02 date 12/11/2020
CAUSE
the wood is too hard
• Degraded battery
• Faulty battery charger
• Unsuitable battery charger
• Motor overheating
• The shear makes noise
Possible electronic or mechanical
problem
REMEDY
Immediately release the trigger. The cutting
blade will go back to its opening position.
• Check that the battery charger is the one
supplied with the shear.
• Replace the battery.
• Replace the battery charger.
Contact an Authorized Service Point
Contact an Authorized Service Point
Page 27