Emergency Flashers - Toyota AURION Owner's Manual

LIGHTS, WIPERS AND DEFOGGER
The headlight high beam indicator light (blue
light) on the instrument panel will tell you that
the high beams are on.
Flashing the high beam headlights (posi-
tion 3)—Pull the lever all the way back. The
high beam headlights turn off when you re-
lease the lever.
You can flash the high beam headlights with
the knob turned to OFF.
TURN SIGNALS
To signal a turn, push the headlight/turn
signal lever up or down to position 1.
The ignition switch must be set to ON.
The lever automatically returns after you
make a turn, but you may have to return it
by hand after you change lanes.
To signal a lane change, move the lever up
or down to the pressure point (position 2) and
hold it.
If the turn signal indicator lights (green lights)
on the instrument panel flash faster than nor-
mal, a front or rear turn signal bulb is burned
out. See "Replacing light bulbs" on page 274
in Section 7--3.
92

Emergency flashers

To turn on the emergency flashers, press
the switch.
All the turn signal lights will flash. To turn
them off, press the switch once again.
Turn on the emergency flashers to warn other
drivers if your vehicle must be stopped where
it might be a traffic hazard.
Always pull as far off the road as possible.
The turn signal light switch will not work when
the emergency flashers are operating.
NOTICE
To prevent the battery from being dis-
charged, do not leave the switch on
longer than necessary when the engine
is not running.