Adjustment For Main Part - Panasonic KX-TDA0155CE Service Manual

KX-TDA0155CE
9.2.

Adjustment for Main Part

9.2.1. Required Equipment
1. Tester
2. Frequency counter
3. (PC)Personal Computer with serial port (Windows 2000/98 or previous version)
4. Power supply adaptor (PSZZ1TDA0142)
5. Service JIG cable (PSZZ2CA155EU)
6. AC Adaptor (KX-TCA1 / KX-A11 / PSLP1434) or Battery Box (PSZZTD142CE)
7. TEL cord
9.2.2. Preparation
1. Remove the under cabinet (Refer to 7. Disassembly and Assembly Instructions)
2. Remove 2 antennas from CN900 and CN901 (Refer to 7. Disassembly and Assembly Instructions)
3. Remove the P.C.B from the upper cabinet (Refer to 7. Disassembly and Assembly Instructions)
4. Connect PC to the CS by service JIG cable
5. Start up the PC and start the hyperterminal
6. Set the hyperterminal property as follows
serial port setup
Port COM1
Bit per second 19200
Data bits 8
Parity None
Stop bit 1
Flow control Xon/Xoff
serial port setup
check next check boxies
ASCII Receiving - Append line feeds to incoming line ends
Warp line that exceed terminal width
7. Set DIP switch pin 2 to 6 from OFF to ON.
8. Supply a voltage to the TEL jack from the AC adaptor (KX-TCA1 / KX-A11 / PSLP1434) via power supply adaptor
(PSZZ1TDA0142)
All manuals and user guides at all-guides.com
24