Panasonic KX-TDA0155CE Service Manual page 29

7. Connect the PC to the CS by service JIG cable
8. Start up the PC and start the hyper terminal
9. Set the hyper terminal property as follows
serial port setup
Port COM1
Bit per second 19200
Data bits 8
Parity None
Stop bit 1
Flow control Xon/Xoff
serial port setup
check next check boxes
ASCII Receiving - Append line feeds to incoming line ends
Warp lines that exceed terminal width
10. Supply a voltage to the TEL jack from the AC adaptor (KX-TCA1 / KX-A11 / PSLP1434) via power supply adaptor
(PSZZ1TDA0142)
9.3.4.2. Adjustment (Modulation) Test
Description of Modulation Calibration Process
Text following "Command:" is the input command for the terminal connected to the CS.
Text following "Response:" is the terminal display response data.
Confirm the response before proceeding to the next step. If no response is set. Shut off power and repeat from the beginning.
Note:
Make sure to set all DIP switches to OFF after adjustment.
All manuals and user guides at all-guides.com
29
KX-TDA0155CE