Setup; Part Names And Functions; Led Indicator; Setup Overview - Panasonic KX-HNS105C Installation Manual

Part names and
functions
Horn
Strobe light
Flashes when the siren is
sounding.

LED indicator

MHIGHN/MLOWN
Used to adjust the siren's volume
(page 12).
Rear cover
M
Used to register the siren to the
hub.
For assistance, visit www.panasonic.ca/english/support
HNS105C_(en-en)_0224_ver.020.pdf
A B C D
E
F
N
7
LED indicator
You can use the LED indicator to
confirm the siren's status.
Indicator Status
Green, lit Normal operation
Red, Siren is not registered
blinking to a hub
slowly
Red, Siren is out of range of
blinking the hub
Red, Alarm system was
blinking triggered
quickly
Green, Registration mode
blinking (You pressed and held
M N)
Off No power

Setup overview

1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Registration
Required only if the siren was
purchased separately (i.e., not as
part of a bundle).
3
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.

Setup

7
2015/02/24 15:12:14