Setup; Part Names And Functions; Led Indicator; Setup Overview - Panasonic KX-HNS102C Installation Manual

Part names and
functions
Infrared sensor

LED indicator

MHIGHN/MLOWN
Used to change the sensor
sensitivity (page 14).
Rear cover
M
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
You can press M
LED indicator to confirm the sensor's
status.
After confirming the sensor's status, we
recommend turning the LED indicator
off by pressing M
For assistance, visit www.panasonic.ca/english/support
HNS102C_(en_en)_0118_ver.301.pdf
A B C
E
N
N and check the
N again as soon
7
as possible, otherwise battery life may
be reduced.
Indicator Status
Green, lit No motion detected
Red, lit Motion was detected
Red, Sensor is out of range
blinking of the hub
Green, Registration mode
blinking (You pressed and held
slowly M
Off No battery power
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
D
been registered (page 8).

Setup overview

1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The motion sensor is battery
powered.
3
Registration
Required only if the motion sensor
was purchased separately (i.e.,
not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the motion sensor in the
desired location.

Setup

N)
7
2017/01/19 20:37:09