Setup; Part Names And Functions; Led Indicator; Setup Overview - Panasonic KX-HNS104C Installation Manual

Setup

Part names and
functions
Microphone

LED indicator

MHIGHN/MLOWN
Used to change the sensor
sensitivity (page 16).
Rear cover
M
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
You can press M
LED indicator to confirm the sensor's
status. After confirming the sensor's
status, we recommend turning the LED
indicator off by pressing M
as soon as possible, otherwise battery
life may be reduced.
8
PNQX7289YA_(en-en)_0907_ver.200.pdf
A B C
E
N
N and check the
N again
For assistance, visit www.panasonic.ca/english/support
8
Indicator Status
Green, lit No glass break
detected
Red, lit Glass break was
detected
Red, Sensor is out of range
blinking of the hub
Green, Registration mode
blinking (You pressed and held
slowly M
Off No battery power
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
D
been registered (page 9).

Setup overview

1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The sensor is battery powered.
3
Registration
Required only if the sensor was
purchased separately (i.e., not as
part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the sensor in the desired
location.
N)
2015/09/07 16:13:55