Advertisement
ASSEMBLY & OPERATIONS MANUAL
STEP 9 <continued> Insert lower portion of
deflector control rod through the metal slot
attached to deflector shield. With deflector in
the raised position, insert the deflector control
rod from outboard position towards the
inboard position and through metal loop.
Secure rod with infinity spring clip (9.4).
1 x
9.4
The unit was shipped with this spare hardware:
- Cotter pin (for retaining tire)
- (2) 2 ¼" stainless bolts
- (2) ¼" stainless nuts
STEP 10: Place screen inside of the hopper so that
the cutouts align with hoppers interior shape.
10.1
18126
STEP 11: Place hopper rain cover on the unit.
STEP 12: Remove the four gear box cover halves.
Using a grease gun, lightly lubricate grease fittings
12.1 on the axle bearing housings and gear carrier.
The bearings are already lubricated from the
factory so there is no need to put more than 1
handle pump into the fitting. Do not overfill. Apply
a small (less is more) amount of grease to the gear
teeth 12.2.
Re-install the four gearbox cover halves and secure
with the three retainer clips 12.3.
P80000_M52098_Rev_June2020
12.1
3x
9.4
10.1
12.3
12.3
12.2
12.1
PAGE 7
Advertisement
