Advertisement
ASSEMBLY & OPERATIONS MANUAL
ASSEMBLY:
20 minutes
STEP 1: Remove from the box and set aside the
hardware pack containing control rods, deflector rod,
and calibrator keys. Also remove the wheel, hopper
cover, and screen.
STEP 2: Remove all inserts from the box to release the
hopper and frame assembly.
STEP 3: Lift the hopper frame assembly out of the
box and place on level surface. Remove the
second wheel from the box and set aside. Place
the hopper on a level surface in the following
orientation. Notice the holes in the axle. One is
inboard and one is in an outboard location to the
centerline of the spreader.
(A) Inboard
Locate two quick release tire clips from the
hardware bag. Orient both tires with the longer
portion of the hub facing inward.
P80000_M52098_Rev_June2020
(B) Outboard
Spring clip
& spacers
STEP 4: Start with the inboard (A) tire and insert
(4.1) the wheel spring clip through the hole of the
orange rim, through the axle, and then flip (4.2)
the spring clip over the axle.
Spring clip
4.1
STEP 5: Move to the outboard (B) tire. Slide the
tire on the axle and install one spacer on the wheel
spring clip (5.1). Then put the spring clip through
the axle hole on the outside of the orange rim.
Install a second spacer on the wheel spring clip and
flip (5.2) the clip over the axle as shown below .
Push rim inward while inserting spring clip through
the axle. The tire should rotate freely.
5.2
5.1
4.2
PAGE 2
Advertisement
