Advertisement
ASSEMBLY & OPERATIONS MANUAL
STEP 15: Start with left hand lever. Push the lever forward to
"open" position. See Image (15.1) below. Verify the opening
size using one of your calibration keys shown in image (15.2).
15.1
YOUR KEY WIL GO DIRECTLY INBOARD OF THE AGITATOR
(15.2). The FLAT portion of the key should be facing the
handlebars.
• If the key will not fit, that shutoff will need adjusted to
be more open.
• If the key is not contacting both sides, that side will
need adjusted to be more closed. (see threading detail
at right).
STEP 16: To adjust shutoff for BASELINE calibration:
Tool required: two 1/2" wrenches
• Push that lever forward to the open position
and loosen the nuts (16.1)
• Thread the nuts (both) in the same direction
needed. Making many small adjustments is
much more effective than making fewer big
adjustments until you are satisfied with the fit
of the calibration key.
• Tighten each nut (16.1) against the shut off
pivot
• Repeat this process for the other side.
Now that you have completed the baseline adjustment for
both sides, recheck the unit to fine-tune the calibration.
The next step will fine tune the spreader to reach the final
accuracy for maximum performance.
P80000_M52098_Rev_June2020
15.2
Thread up, opening
shut off
Thread down, closing
shut off
Flat side towards
handlebars
Key cross section
16.1
PAGE 9
Advertisement
