Advertisement
ASSEMBLY & OPERATIONS MANUAL
CALIBRATION:
STEP 13: Your spreader should be calibrated before first
use. Once complete, the spreader should not need
further calibration unless the spreader is disassembled
or damaged.
STEP 13.1: If the pointer is not set at setting "I", pull
both shut off handles back to the closed position.
Loosen the rate plate knobs (13.2). Slide the (13.1) rate
control plate to the right until you reach the "I" setting.
Tighten the rate plate knobs (13.2).
A B C D E F G H I J K L M N O P
STEP 14: Remove the lever tether pin (14.1) so that
the handles move independently. Each side is to be
calibrated individually. For this process, it is best to:
• Have your unit on the ground in an upright
position
• Keep your tools located close so you can reach
them while manipulating the controls
Tools Required:
o 3/8" Wrench (nut on the rate indicator)
o Phillips screwdriver (Screw for rate
indicator)
o 1/2" Wrench (nut on the control rod)
• Kneel next to the unit, to one side of the unit, so
the handle is to your dominate side
• This is the approach for a right-handed person
• This gives you easy access to both areas you will be
manipulating for this step
P80000_M52098_Rev_June2020
10 minutes
13.1
13.2
14.1
PAGE 8
Advertisement
