Advertisement
Quick Links
Side Deflector Kit
Assembly, Use and Care
Our toll-free number is
Before You Begin ...
To assemble your side
deflector, we highly
recommend that you read
all the instructions thoroughly,
familiarize yourself with the
assembly and components, and
verify that all parts are included
in the package.
You Will Need ...
The following tools:
—7/16" and a 3/8" open-end wrench (or adjustable
wrenches)
—Phillips Head Screwdriver
—Pliers
1-800-225-2639
Model LCO-1000
(U.S. Only)
Advertisement
Related Manuals for The Andersons LCO-1000
Summary of Contents for The Andersons LCO-1000
- Page 1 Model LCO-1000 Side Deflector Kit Assembly, Use and Care 1-800-225-2639 (U.S. Only) Our toll-free number is Before You Begin ... To assemble your side deflector, we highly recommend that you read all the instructions thoroughly, familiarize yourself with the assembly and components, and verify that all parts are included in the package.
- Page 2 Assembly Remove the components from the carton. On the Attach the auxiliary shutoff bracket to the right RH. side of the spreader as shown, remove the side of the upper handle using (2) #10 x 1/1/2” two nuts and lock washers holding the hopper onto the Philips screws and locknuts.
-
Page 3: Operation
Knob Out See diagram for assistance in identifying specific parts. For parts orders, call 1-614-559-2655. (Note: Sales of parts for the Andersons spreaders are handled by PSB Company IMPORTANT: When ordering replacement parts, always provide the following information: 1) Part number (DO NOT use key numbers when ordering parts. ALWAYS use part numbers.) -
Page 4: Warranty
This warranty does not extend to any Product or parts thereof that have been allowed to corrode, subjected to misuse, neglect, accident, or modification by anyone other than The Andersons or that have been affixed to any nonstandard accessory attachment or that have been used, stored, installed, maintained operated in violation of The Andersons instructions or standard industry practice. - Page 5 Spring Bracket Drill Guide Template You will need a 3/16” drill to make the hole. Step 1. Cut the guide below on the cut line Step 2. Position the guide to the right side and above the Pivot Bracket Step 3. Mark the center line of each Spring Bracket hole Step 4.