Installation - Valor G3 Series Installation Instructions Manual

738/739 Mantel Clearances
Mantel width "A"
1"
Mantel height "B"
28" 29 ⅜" 32" 33 ½" 35" 36" 36 ½" 38"

Installation

1. Fasten the outer surround trim and brackets to
the 738/739 heaters or RA24ZC zero clearance
box. Screw the mounting brackets supplied with
the heater or ZC kit to the back side of the outer
surround. Fasten the assembly to the heater or ZC
box as per instructions supplied with the heater or
ZC kit.
2. Assemble the FenderFire Front.
a. Bolt the 4 hinge pins to the FenderFire frame
with the pins pointing up using 2 bolts per set.
b. Bolt the 4 hinges to their respective door using 2
bolts per hinge:
- 2 left hand hinges (part #96-10-510-50)
- 2 right hand hinges (part #96-10-520-50)
c. Place the magnet and bracket over the threaded
studs on the bottom piece of the frame and
secure using the 2 nuts provided.
2
2" 4" 6" 8" 10"
RF24B Mantel Clearances
12" 14" Mantel width "A"
Mantel height "B"
3. For 738/739/RF24B (ZC). Clip the FenderFire frame
onto the brackets of the heater or ZC box within the
outer surround. If the clips securing the FenderFire
frame do not fully engage in the bracket, it may be
due to the bottom piece of the frame getting hung
up on a high spot on the hearth. If this is the case,
loosen the nuts of the bottom piece of the frame
and raise it to the appropriate height.
2" 4" 6" 8" 10" 12"
30" 32" 34" 36" 38" 40"