Configuring Your Power Sensor Via Power Analysis Manager - Keysight Technologies U2000 Series Operating And Service Manual

1 Getting Started

Configuring Your Power Sensor via Power Analysis Manager

1 Go to Start > All Programs > Keysight N1918A Power Analysis Manager > Advance
2 With your power sensor still connected, a pop- up reminder dialog will
3 Click OK and you may proceed to set the calibration due date or
4 To set the calibration due date, go to Instrument Panel, in the System
N O T E
18
> Power Analyzer to launch your Power Analysis Manager.
appear when you launch the Power Analysis Manager. The reminder
message will appear under two conditions:
a You have not set any calibration due date for your U2000 Series. The
reminder prompts you to set your calibration due date.
b Your calibration date is due and the reminder prompts you to send
your U2000 Series for calibration.
connect a new power sensor to proceed.
tab, input the due date of your calibration in the Cal Due Date
property.
For remote interface configurations of P-Series power meters, refer to Remote
Interface Configurations in Keysight P-Series Power Meters Installation Guide
and for remote interface configuration of N8262A P-Series modular power
meters, refer to N8262A P-Series Modular Power Meters Installation Guide.
U2000 Series Operating and Service Guide