1. Crankcase breather hose
2. Clamp
3. Crankcase breather pipe
4. Right crankcase
5. Air filter case
6. Clip
A. The opening can face either right or left.
B. Install by aligning with the white paint.
C. Adjust the knob diagonally to the back.
D. Route the crankcase breather hose above
the tensioner assembly.
E. Adjust the knob to the front.
F. Yellow paint position
G. Install by adjusting to the yellow paint
mark.
H. Insert until contacting the air filter case
(insert 15 mm).
I. Adjust to the Crankcase breather hose
paint and then adjust the knob to the back.
J. Route the crankcase breather hose above
the fuel tank bracket, adjust the paint to the
"6S5" on the hose joint and then install.
K. Clamp the frame and Crankcase breather
hose.
L. Insert until contacting the crankcase
breather pipe (insert 18 mm). (Silicon fluid
can be applied only to the engine.)
2-60
CABLE ROUTING