Yamaha Star XVS950A 2009 Service Manual page 69

1. Fuel delivery hose
2. Sidestand switch lead
3. Clamp
4. Front brake hose
5. Clutch cable
6. Handlebar switch lead
7. Spark plug lead
8. Wire harness
9. Plastic band
10.Front brake hose holder
A. With white tape
B. Route the sidestand switch lead outside of
the shift rod.
C. Clamp the starter motor lead, sidestand
switch lead, AC magneto lead, oil level
switch lead, rectifier/regulator lead, rear
brake switch lead and horn lead. Face the
lock down and cut off the excess end.
D. Clamp the sidestand switch lead. Face the
lock down and cut off the excess end.
E. Clamp the starter motor lead, sidestand
switch lead, AC magneto lead, rectifier/reg-
ulator lead, rear brake switch lead and
horn lead. Face the lock down and cut off
the excess end.
F. Make sure that the lead and harness not
protrude out from bottom of the frame.
G. Clamp the starter motor lead, AC magneto
lead, rectifier/regulator lead, rear brake
switch lead and horn lead. Face the lock
down and cut off the excess end.
H. Clamp the starter motor lead, rectifier/reg-
ulator lead, rear brake switch lead and
horn lead to the engine mount boss. Face
the lock to the front and cut off the excess
end. Make sure to fasten the band to the
engine boss.
I. Clamp the starter motor lead, rear brake
switch lead, horn lead and fuel tank
breather hose. Face the ends of the hose
clamp outside.
J. To the starter motor
K. Route the handlebar switch lead outside of
the clutch cable.
L. Pass the clutch cable through the guide.
M. Route the spark plug lead inner side of the
fuel return hose and fuel hose.
N. Clamp 30 mm within where the frame is
glued.
O. Lead, harness (order insignificant)
P. Face the clamp lock in this area.
Q. Bottom of the vehicle
R. Face the opening of the hose clamp
upward.
S. Clamp the spark plug lead and clutch
cable. Face the clamp lock upward.
Face the clamp end to the right.
T. When fitting to the front brake hose, soap-
suds or silicon fluid can be applied.
U. Press the brake hose against the stopper
and tighten.
V. Insert the front brake hose holder tab into
the stopper hole.
2-46
CABLE ROUTING